Quality Plastic Film and Plastic Sheets
Is acetate suitable for outdoor use? No. We do not recommend using acetate outside, especially for extended durations, because, over time, acetate film tends to swell and shrink with changes in atmospheric humidity. Also, long term exposure to sunlight will eventually cause it to yellow and become brittle. For very short term use (a few … Read more
What is the heat resistance of translucent imaging film (TIF)? TIF is designed to handle the quick heat exposure in a toner-based plain-paper copier/laser printer. Its coatings are designed to be used in environments up to 85C/185F. At higher temperatures, the printable surface could yellow, or lose some of its toner adhesion properties. When TIF … Read more
What is the heat resistance of Shrink-Art Films? Well, it’s fairly low, compared with other films like our DuraLar™ films. It’s even a little less heat resistant than our ClearLay™ Rigid PVC and our acetate film. But that’s a good thing! The whole point of Shrink-Art film is to bake it in an oven and … Read more
What is the heat resistance of our pressure sensitive adhesive (PSA) DuraLar™ films? PSA DuraLar is designed for use in environments below 65C/140F. At higher temperatures, the adhesive becomes soft and loses adhesion. At really high temperatures (above 150C), it begins to lose its orientation; it will become wavy and shrink. If you need a … Read more
What is the heat resistance of Laser-printable (PPC/Laser) film? PPC/Laser Ffilm is designed to handle the quick high heat exposure in toner-based plain-paper copiers and laser printers. Its coatings are designed to be used in environments up to 85C/185F. At higher temperatures, the printable surface could yellow, or lose some of its toner adhesion properties. … Read more
What is the heat resistance of LaserPro™ laser cuttable films? LaserPro films will begin to soften at about 150C/300F. When this films soften, it begin to lose its orientation; get wavy and begin to shrink. So if your film will only be exposed to a heat environment below 150C/300F, LaserPro is a good choice.
